Seat Memory Settings Won’t Save - How to Fix (Steps)

[2025 Big Red]

Aww man! I can't wait to try this after work. Mine hasn't been working (except the steering wheel position). I was thinking I was going to have to take it into the dealership. It's been soo annoying trying to get the seat back to just where I like it after the Wifey drives it. She leaves that seat all the way forward and jacked up to Jesus!

I did I go to dealership. All they did was hold Set and #1 at the same time and worked. I was pressing Set, let go, and then pressing#1. Worked after that.

Sponsored

 

[Cityzen10]

Easy fix, I bought the wife the car she wanted. Now I'm not allowed in it and she's not allowed in mine

I'll have mine paid off in a few weeks, I like your style, I may just do the same. After letting her drive it a few times, she's getting a little too comfortable in it for my liking.

 

[beanmachine]

Thanks for this tip!

Totally worked for mine also.

Dealer apparently didn’t do PDI on tire pressures either… I was rolling around on 45psi. I hadn’t figured out how to check the on board monitor when we left the dealership after a long wait. Didn’t check it until a few days ago and 430 miles on Odo.

Rides so much better at 34psi!

How did you get the correct reading for tire pressure?

 

[RogueWarrior65]

Okay, so, I needed to do the calibration procedure because the seat would beep as I was moving it. That's fine BUT, the memory button still doesn't do squat. What's worse is that if the seat got moved for some reason e.g. I leaned on one of the controls as I was trying to reach for something, that position becomes the new startup position. WTAF? Is there any way to clear everything out and start over? Is the key fob messing with me? I never tried to program that.

 

[Nodak]

you sure the set button isnt stuck in the down position?

you have to press the set and 1 or 2 button to set a pre-set

if you can press the 1 or 2 button without the set button, to set a pre-set then something is wrong.

 

[RogueWarrior65]

I'm a bit mystified by the calibration procedure. It uses forward/back and recline, both of which make perfect sense. But then it uses "up/down". Which one? The up/down control does two things. The YouTube video mentioned above uses the front part of the seat but not the whole seat. And why isn't the lumbar control part of this?

Sponsored