Rattles when on cobble stone

[nulled]

I noticed few annoying rattles when on cobblestone:
- When there is bottle in the bottle holder in the middle, the plastic adjusters vibrate badly. Goes away mostly when I remove the bottle.
- Rattle from the driver's door but couldn't figure out where it's coming from. Maybe the speaker grill?!
- The seatbelt on the passenger side.

Have you noticed any bad vibes yourself?

Sponsored

 

[taycanstuff]

Definitely the seatbelt passenger side, need to adjust the clip slightly so it doesn't rattle when no passenger.

 

[Minternico]

I noticed few annoying rattles when on cobblestone:
- When there is bottle in the bottle holder in the middle, the plastic adjusters vibrate badly. Goes away mostly when I remove the bottle.
- Rattle from the driver's door but couldn't figure out where it's coming from. Maybe the speaker grill?!
- The seatbelt on the passenger side.

Have you noticed any bad vibes yourself?

I can’t take the noise on the seatbelt banging against the side door.. you would think at $100 k you would have stuff like this figured out.. and I have asked my dealer three times to address… no response …

 

[jh6284]

I can’t take the noise on the seatbelt banging against the side door.. you would think at $100 k you would have stuff like this figured out.. and I have asked my dealer three times to address… no response …

It is addressed in the manual

Securing seat belt for passenger seat

1. If the passenger seat is unoccupied, the belt tongue can be placed near the belt outlet on the B-pillar trim panel to avoid contact noise with the plastic slider A (Fig. 2).

 

[Fadz]

Passenger side seatbelt noise banging everywhere there is annoying since day 1. But I temporarily eliminate the noise. Just fasten the seatbelt all the time with or without passenger and it works no more noise.

 

[shawn]

Easier to do what jh6284 points out above. Per the manual the belt already comes with a slider to stop the noise.

 

[prime]

It is addressed in the manual

Securing seat belt for passenger seat

1. If the passenger seat is unoccupied, the belt tongue can be placed near the belt outlet on the B-pillar trim panel to avoid contact noise with the plastic slider A (Fig. 2).

That’s kind of hilarious they have that in the manual.. should not even be an issue, but at least it’s an easy fix. I ordered a few more of those clips for the remaining seatbelts just in case.

Sponsored