Dashcam installation issues -- fuse box location?

[Fleming23]

I just installed my front a rear fitcam yesterday. For the most part the videos online show enough to get it done. There is video of a guy who installed one on a 2024 cayenne that was helpful. everything came apart and went back together relatively easily. I found it easier to install the camera and route the wires and then put the mirror back on. Routing the cable to the back took some time, and getting it through the grommets to mounting place took some time.

Do you mind sharing which Model you used from fitcam (A/B/C)? I haven't given it enough of a look, but Fitcamx cannot use the factory pre-wire, correct? Meaning you have to go to a fuse box to hardwire, or did you go to the sensor wire in the overhead console as they suggest?

 

[verdee]

I used model A. I did not have the factory dash cam prep. I just used the fitcam harness that connects to the mirror power plug. I considered fuse box to hardwire, but decided I didn’t want the hassle. My car is garages most of the time or ina secure lot, so I wanted it more forwhile driving

 

[bbmertz]

my SA told me as long as you have the harness pre installed (ordered) it is much harder for Porsche to make a case against any dashcam. they would now only have to find a way to prove you installed it wrong. BTW i am planning on the DR770x box version for my Turbo when it arrives. ( i just installed one on my e-tron) it is great to know you can access/see the car anytime you like. no 4k but at least 3ch.

Would you recommend buying the Blackvue battery pack (B-130X) even if my Blackvue dashcam (DR970X Box 2-CH Plus or 2-CH LTE Plus) will be hardwired? It’s quite expensive at $359 but I would get it if necessary to protect the Macan’s 12v battery when in parked mode.

Btw, my local installer said that he’s unable to use the Porsche dashcam prewiring since they “cannot connect to the oem dash cam harness as that uses can bus instead of the traditional 12 volt power to turn the camera on and off. We are better suited running to the fuse box so we do not upset any of the circuits in the vehicle.” Does that sound right?

 

[krissrock]

ooh that FitCam actually looks pretty nice. Super stealthy.... but those videos on the website are anything but convincing that it's easy to install lol

 

[gregb]

Btw, my local installer said that he’s unable to use the Porsche dashcam prewiring since they “cannot connect to the oem dash cam harness as that uses can bus instead of the traditional 12 volt power to turn the camera on and off. We are better suited running to the fuse box so we do not upset any of the circuits in the vehicle.” Does that sound right?

I am not an electrical engineer, but that does not sound right. Check out the camera installation on a taycan here. As far as I can tell, the prewired wires run directly down to the fusebox and are not part of any can bus. I am basing this assumption on the fact that the porsche instructions for installing a prewired camera call for a new fuse to be inserted into the fuse box to protect the camera. This makes me believe that the prewired cables are not "live" until the fuse is added to the fusebox.

The easiest way to check would be to get the prewired connections our and test the connections via a multimeter.

Sponsored