Sharing Exp- installed BLACKVUE DASHCAM – DR970X-2CH LTE

[someTimesJoe]

That looks good and clean!
Didn’t realize that there was that much room for the box. I ended up putting my own air compressor and tools in that spot.
More room in the Taycan and should have swapped the box setup from the Taycan to the Macan and used the full DR970 instead.

Sponsored

 

[someTimesJoe]

Anyone using ODBC port as power? I have it for power for the last 3 months but seems like a recent firmware update, it sleeps now when parked. DR970X -2CH setup and working totally fine and using the Macan’s hotspot while driving. When you get in the car, it gets out of sleep and starts recording. Before all of this, you can see the LED status lights and when it detected motion, it’d blink. I’ve tried turning off the low voltage cutoff and then keeping it on but lowering the threshold to the lowest it’ll let me.
Curious if anyone else seen this?

 

[BigApple]

i use the obd port and it works fine but i dont have that cam model i use the 3ch 770x box pro.

 

[TaycanEagle]

I had great success with the BlackVue 970x LTE Plus. Initially, we hardwired the setup, and I found the parking mode feature very accurate. I never worried about draining the 12v battery because of the voltage cutoff capabilities. However, a few months later, I added the blackbattery to increase the camera’s operating time when parking for extended periods. So far, I’ve managed to go 15-18 hours in parking mode with the BlackVue battery having about 80% charge. I’m impressed with the app, camera quality, alerts, and the ability to customize modes.

Sponsored